Measured, plumb and level
Frame set square so the door swings true.

Entry Doors
A new entry door should close with a soft click, seal against the weather and look right from the street. That comes from careful measuring, a plumb frame and the right shims, flashing and sealant.
Call or text today615-431-3789Entry Door Installation
The front door is the first thing visitors see and the opening that takes the most weather. A door that is even a quarter inch out of square will stick, leak air or fail to latch, no matter how good the door itself is. Installation matters as much as the slab.
We install entry doors for homes across Nashville and Middle Tennessee. We measure the opening, set a level sill, shim and fasten the frame plumb, flash the head and sill, insulate the gap and adjust the hinges and strike so the door swings freely and latches with a light push.
What you get
Frame set square so the door swings true.
Head and sill protected from water.
Air leaks around the frame closed.
Hinges, strike and sweep set at the end.
The process
We check the opening, swing, sill and your choice of door and hardware.
The frame is set, shimmed, fastened, flashed and sealed.
We adjust the fit, test the lock and show you how it works.
FAQ
Many single doors take a half day to a day. Doors with sidelites, transoms or masonry work take longer.
Yes. We check the unit for damage and fit before we install it.
We install and caulk the trim and can coordinate or complete the paint and stain.
Related services
Service areas
From Clarksville to Shelbyville and Dickson to Cookeville, pick your city to see the door installation, repair and garage door work we handle in your part of Middle Tennessee.
Not on the list? Call 615-431-3789. We take projects across Middle Tennessee.
Call, text or send the form. Tell us about the door, what bothers you and when you hope to start, and we will take it from there.